Chrome & Stainless Steel Engine Accessories
Fuel Rail Polished Stainless Cover Set (2pcs)
2 piece set of polished fuel rail covers simply attach over factory fuel rail covers.
Intake Polished Stainless Cover Set (2pcs)
Covers sit on top of Corvette factory intake manifold. Covers are perfect place to
affix an emblem.
Radiator Shroud Polished Stainless Cover Set (2pcs)
Covers affix across top of factory radiator shroud on either side of intake covers.
Measure 10.25” x 12.25” x 10”.
Front Insert Panel Polished Stainless
Cover & Hardware
Fills gap area where hood meets front where hood meets front area in engine compartment.
Once installed fills front open area.
Measures 28”x2.25”. Comes with chrome-plated hardware.
Inner Fender Sections
Polished Stainless Cover Set (2pcs)
Pre-bent to cover inner side fender area of C6.
Engine Compartment Inner Fender
Chrome-plated Detail Screw Kit (14pcs)
Replace factory original Torx head screws that secure inner fender to each side.
Hood Shocks Chrome-plated Covers (2pcs)
Engine Accent Chrome-plated Cap Set (4pcs)
Fits oil fill, power steering reservoir, brake reservoir and radiator reservoir cap.
Designed to slip over factory caps.
Machined Polished Billet Radio/Heater
Ring Set (4pcs)
Simply puts a thin plastic chrome ring on radio/heater knobs to dress them up. Woks
on C6 with navigation. Easy to install.
Master Cylinder Brake Reservoir
Cap Chrome Cover
All one piece. Top portion is vented like original.
Made of copper with chrome plating for lasting quality.
Power Steering Cap Chrome Cover
Designed to slip over factory original power steering cap. Has small vent hole like
original. Made of copper with chrome plating for lasting quality.
Oil Fill Cap Chrome Cover
Designed to slip over factory original black oil cap found on valve cover.
Alternator Polished Stainless Cover
Cover is vented to match intake polished stainless cover.
Measures 9 3/4” x 4”. Includes hardware.
Triple Chrome Plated Hood Latches (pair)
Hood strikers are triped chrome plated. Comes with 4 new stainless washers and 4
Brake Booster Polished Stainless Cover
Attaches to top portion of brake booster. Is curved cover that covers top portion
of brake booster behind brake reservoir.
Brake Reservoir Polished Stainless Cover
Covers top and also extends down exposed side of brake reservoir. Cover is slotted.
Measures 3.5” x 6.75” x 5”. Easy to install.
Power Steering Reservoir Housing
Polished Stainless Cover
Covers top surface and visible side facing drivers side fender of housing. Measures
2.25” x 3.5” x5”. Easy to install.
Air Conditioning Check Valve
Chrome Cap Covers (2pcs)
Located on passenger side in engine compartment. Each main has capped valve (fill
point) that has black plastic cap on valve opening.
Windshield Washer Reservoir Cap
Made of copper and chrome plated. Measures 2.25” in diameter.
Windshield Washer Cap Chrome Cover
Easy to install, just slips over existing cap.
CLICK HERE TO VIEW
Chrome Front Air Grill Moulding
Z-06, ZR-1 & Grand Sport.
CALL FOR PRICING
© Copyright 2014. Bair’s, Inc. All Rights Reserved.
Corvette is a registered trademark of General Motors Corporation and Chevrolet Motor
No challenge to ownership is implied.